Electric vs. LP Appliances

I think you need to look at the pro/cons of each. Add the cost of a quality genny to the cost difference between elec & LP. Factor in the noise while vending, comp or catering. You could drop down to a 2k gen to run the few things LP won't run. I can't think of any equipment that runs better on elec than LP. I'd also be looking at going 8' wide instead of 7'. That extra foot makes a lot of difference for the cost.

Dan is right, that extra foot width is a must. I went with 8.5 foot height as well, and that is so great!

I would go LP on the appliances possible. It's just simpler and more efficient than a bigger generator, or multiple generators.

I have that 7000 Honda, and it is fantastic! The food trucks around me run the cheap generators. I'm there first, cooking early like a good bbq guy, and it's all peaceful. Then the taco and asian trucks show up, and the cheap generators start, an it's a noise festival.

VitoCorleone said:

Thanks for the feedback Dan! I've seen a lot of people reference a Honda 7000 generator on here. I looked and they are around $4K. Even if I spent the extra money though they only have 2 20 amp outputs and 2 30 amp outputs. I'm no electrician, but how does that get me any more running power than a cheaper model from Sam's Club? if 30 amp is the most they can get to the panel, then don't I only have 30 amps to work with?

I've been debating the 8 foot option lately. The first manufacturer I talked to only offered a 7 or 8.5 and VA gets a little grey on some issues with the 8.5 (they consider it a wide load). I think I picked 7 because of that limitation then and just kept going with it. Most places do offer an 8 foot choice though so I will definitely revisit the size. Thanks!

Click to expand...

With the length of your trailer the 8.5 will hinder the placement of appliances in the trailer due to the wheel well. Please don't ask me how I know:twitch: Now as far as electric goes for everything you have outlined that you wanna do with this trailer your going to want to use mostly propane. I was at a comp a few weeks back and had to run the generator because of the small A/C unit I added. Neighbors thought it was quit annoying but they where camping so.... to change the subject where ya going to sleep during the comps, mind you you wont get much so that might not be a biggie.

I have a 15 X 8.5 Haulmark dual axle it does ok but I don't have the three sink and hand sink installation. I just carry a 55 gallon approved rain water barrel for washing dished and a 160 qt crab pot and propane burner for a heat source. Good luck. My analyses of what you have said based upon my experiences would be that you need the at least a 20 x 8.5 with a raised roof to accomplish what you want to do. If you have a class c RV or are comfortable sleeping in the tow vehicle you might not need the longer trailer. Bigger is better if you can afford it. BTW the Champion line of Inverter/generator is pretty quiet. I bought a 3400 Dual fuel and love it. I'll never use gasoline unless it's an emergency the wattage rating drops on Propane to 3100.

VitoCorleone said:

Thanks for the feedback Dan! I've seen a lot of people reference a Honda 7000 generator on here. I looked and they are around $4K. Even if I spent the extra money though they only have 2 20 amp outputs and 2 30 amp outputs. I'm no electrician, but how does that get me any more running power than a cheaper model from Sam's Club? if 30 amp is the most they can get to the panel, then don't I only have 30 amps to work with?

Click to expand...

It has a lot more to do with noise levels than electrical output.

VitoCorleone said:

Even if I spent the extra money though they only have 2 20 amp outputs and 2 30 amp outputs. I'm no electrician, but how does that get me any more running power than a cheaper model from Sam's Club? if 30 amp is the most they can get to the panel, then don't I only have 30 amps to work with?

Click to expand...

Each circuit is independent so you can run 2 20 amp circuits and one 30 amp. My trailer is all electric and I have 2 20amp and 1 30 amp independent inputs. One 20 runs the AC and the other 20 runs the hot water heater, refrigerator, and overhead lights. The 30 runs the kitchen; induction burners, appliances, etc.

Slamdunkpro said:

Each circuit is independent so you can run 2 20 amp circuits and one 30 amp. My trailer is all electric and I have 2 20amp and 1 30 amp independent inputs. One 20 runs the AC and the other 20 runs the hot water heater, refrigerator, and overhead lights. The 30 runs the kitchen; induction burners, appliances, etc.

Click to expand...

Dude, I'm leaning something: I can run the 30 amp circuit, and the two 20 amp circuits also at the same time? I have been doing it wrong!!!

PaulstheRibList said:

Dude, I'm leaning something: I can run the 30 amp circuit, and the two 20 amp circuits also at the same time? I have been doing it wrong!!!

Click to expand...

Yes but you can't draw more that 57amps combined at one tme.

Slamdunkpro said:

Yes but you can't draw more that 57amps combined at one tme.

Click to expand...

Roger that.

Slamdunkpro said:

Each circuit is independent so you can run 2 20 amp circuits and one 30 amp. My trailer is all electric and I have 2 20amp and 1 30 amp independent inputs. One 20 runs the AC and the other 20 runs the hot water heater, refrigerator, and overhead lights. The 30 runs the kitchen; induction burners, appliances, etc.

Click to expand...

Awesome post! You just solved a major, head beating dilemma that we have been experiencing.