D
dkruks
Guest
my CS-450 seems to be going through a lot of pellets,i know that i have been doing relatively high heat cooks for a pellet grill around 300* to 350*...in my 5 cooks so far i have used over 20lbs of pellets... the manual says that at medium setting(on the dial) should run at 350*...was told that the medium setting would use about 1lb of pellets/hour...when i have the dial set to medium the temp is about 190* i have to be almost set to high to achieve 350*....this doesn't seem right to me.
My question is, at the top/rear of my barrel there is 5 - 1 inch vent holes, would i do any type of damage if i blocked 1 - 2 or 3 of them to try to keep my heat up inside to lower my dial setting and us less pellets?
any advice would be greatly appreciated
Thanks,
Dave
My question is, at the top/rear of my barrel there is 5 - 1 inch vent holes, would i do any type of damage if i blocked 1 - 2 or 3 of them to try to keep my heat up inside to lower my dial setting and us less pellets?
any advice would be greatly appreciated
Thanks,
Dave