Clay-b-que
is Blowin Smoke!
I have a tank just like this that I am going to try to build a big UDS out of. If that doesn't work, I will be turning it into something like this. Nice work!!!
Nice work!!! Can't wait to see some Q on it. How long did it take start to finish?
This turned out beautifully! I'm planning a similar build soon with a 120 gallon 304 stainless tank. A few questions if you don't mind. Please and thank you!
1) Was your tank a seamless pipe or a rolled and welded pipe? You should be able to spot a continous weld down the length of the tank cylinder if it's rolled/welded. I ask because I wonder if a seamless pipe will spring out in the door panel when it gets cut out, or if that's something that happens in roll-formed cylinders since there's tension in the pipe. I assume the door wanted to spring open flat?
2) What was the approximate tank wall thickness?
3) How easy was it to get the warp out of the door?
Yea I completely Dig on this.. Plan on building one about this size for my father in law within the next couple of years..