rovertech001
Well-known member
Hello all,
I'm building my first UDS and need a little help. I drilled three 1" holes in the base, equally spaced ,as air vents. I have used 3/4" X close pipe nipples with electrical conduit nuts to snug everything up. I will be using a 90 degree elbow and 10 inch extension to get the ball valve a little higher and make it easier to operate. I can't seem to tighten the conduit nuts enough to keep the vertical pipe tight. I see plenty of people using this same setup but don't see anyone complaining of this issue. Am I missing something?
I'm building my first UDS and need a little help. I drilled three 1" holes in the base, equally spaced ,as air vents. I have used 3/4" X close pipe nipples with electrical conduit nuts to snug everything up. I will be using a 90 degree elbow and 10 inch extension to get the ball valve a little higher and make it easier to operate. I can't seem to tighten the conduit nuts enough to keep the vertical pipe tight. I see plenty of people using this same setup but don't see anyone complaining of this issue. Am I missing something?